A Beginner’s Guide to Setting Up a Tattoo Workstation

When it comes to setting up a tattoo workstation, your chief focus should be sterility. You may want to restrict the possibility that anything you do will cause contamination of the tools and put you as well as your client, in jeopardy. Due to this incredibly pressing need, a proper workstation is possible only in a licensed studio. Even when extraordinary measures are undertaken to set up a station someplace else, the risk is higher than with a studio where stringent guidelines are in force.

According to the experts providing top-notch tattoo equipment Australia, a workstation must be clean. It is not an office, a living room, and definitely not a café. Paperwork, drawing, and discussions with clients before and after the session, internet research, and other business operations must be performed outside the workstation. Although not viable, this is considered best. Drinking and eating are prohibited, and only items needed should be kept in the station.

A workstation must have a non-porous, clean surface. All the furnishings inside the station must be non-porous, or in other words, manufactured from glass, plastic, metal, and vinyl. They require proper maintenance. Torn or broken items should be repaired or replaced immediately. Regular maintenance can keep factors that may delay tattoo application or create problems for the tattoo artist at bay. Knowing when and what to touch alleviates the chances of adverse reactions.

Start by washing your hands thoroughly using lukewarm water and an antibacterial cleanser. Make sure to clean between your fingers, beneath the nails, and right up to your elbows. Wear a pair of medicated gloves. Several stations have a glove box near the entrance of the station. For further information, please check out the given write-up.

1.      The professionals offering the best tattoo equipment Australia said to spray the workstation - chairs, tables, and trays - with a disinfectant. While some states require it and others do not, it will be good to label the bottles having liquids in the workstation, if only to enable the client to ascertain what is used. Let the disinfectant sit on the workstation for at least three minutes before wiping it with paper towels.

 

2.      All the containers and bottles placed on the table should be made up of non-porous materials and must be cleaned with disinfectant. Again, place only what you need for tattooing - rubber band jar, ink cap jar, green soap, ink, power supply, paper towel, and clip cord. The foot pedal should be plugged in and kept on the floor.

 

3.      The liquid containers must be full before you keep them on the table as a measure to avoid the requirement to refill the bottle during tattooing. Place barrier films on the surfaces you may contact, such as power supply, clip cord, and work lamps.

 

4.      Place the tubes and needles on the dental bib or inside autoclave bags. Leave them sealed until the client is present for the tattoo to be assured they are getting clean or new needles and tubes.

Although the exact setup varies from one artist to another, the tips mentioned above are fairly common. The entire focus of the procedure is to avoid cross-contamination under all circumstances. The more you exert effort to protect yourself and your clients, the successful your business will be.